DuraHoist 2inch Ball Hoist Adaptor (Dada DH-16 WSG)

The 2” Ball Hitch Adapter installs between the DH-12 and the attendant vehicle and mates with all standard 2” ball hitches.

Materials

General Construction: Welded Steel
Weld Certification: AWS
Finish: Zinc Plated
Hardware: Gr. 5 Zinc Plated
Plating Specification: ASTM Designation
B633-85, Type II, SC2

Technical
Working Load: 450lbs (204kg)
Design Factor: Dependent on other system components, minimum 4:1 Design Factor
Weight: 19lbs (8.6kg)

Application Restrictions
2. Only one extension at a time is to be used with a hitch mounting sleeve. Multiple hitch mount sleeve extensions are not to be used.
3. The standard Hitch Mount Sleeve is to be used with a maximum 30” (762mm) offset mast.
4. Anchoring to an attendant vehicle may not be permitted within certain jurisdictions. Ensure that use of this equipment does not violate any regulations within your area.
5. The 2” Ball Hitch Adapter must be served directly to vehicle, not between a Hitch Mount Extension and Hitch Mount Sleeve.
6. Each installation must be approved to local standards by a qualified engineer.